Recommended Products
5.8GHz Premium Combo
This antenna combo is similar to our pupular “Bundle and Save kit”, the only difference is the transmit antenna is a Pentalobe version 2 antenna.
The Pentalobe offers extra gain and world class quality. You will experience video transmission with no lines and blemishes.
Chat with us on Facebook reguarding your upgrades
https://www.facebook.com/groups/1577806512440602/
and also here
https://www.facebook.com/groups/396477587202912/
Note: Please select the plug you want before adding the product to cart.
RHCP 5.8GHz Parasitic Disk Helix 9.3dBi-Fatshark mount- For 3-4km racing quad
This is a new development for FPV antennas. It’s a 2.75 turns helix, the turns are more closely spaced than a conventional helix, and it uses a parasitic disk to achieve higher gain (9.3dBi) and better axial ratio compared to a regular helix.
The result is a very compact moderately directional antenna with very good efficiency, and same gain as a 3 turns conventional helix. The total length is less than half that of a comparable 3 turns helix, which is slightly more than a linear patch antenna which shines if attached directly to your FPV goggles. The ease of aiming this is unbelievable it feels almost as an omni when flying your course nearby and it becomes slightly directional with very wide beam width when going far. We have taking our racing quad to 3-4km with a 200mw VTX and this antenna.
Note: Please select the plug you want before adding the product to cart.
RHCP 5.8 GHZ tx Pinwheel 90° SMA
A single tx pinwheel for 5.8Ghz. This antenna comes only with a 90° connector, for straight connector please select the proper item in the list. This one works very well with our 5.8 helicals….
After much testing and reports by customers I can say it outperforms most of the cp antennas out there.
Note: Please select the plug you want before adding the product to cart.
RHCP 5.8 GHz Pentalobe V.2 1.9dbi
I developed this new Pentalobe V.2, which is an evolution not a revolution of a OMM optimized pinwheel. WIth slight more pitch angle an an extra lobe, gain and circularity are improved. Also this antenna is a better match to 50ohm compared to the older pentalobe.
Note: Please select the plug you want before adding the product to cart.
Shop
Showing 49–70 of 70 results
-
5.8GHz FPV Antennas
RHCP 5.8 GHZ 4 -1/4 turns Helix
This Helix has a lower gain, as compared to our 8 turn one, and can be used in  place of a patch for Circular Polarization. with a gain between 6.5-8 dbi , it can be used without a tracker, just aim in the general direction of flight! It can be also made with a 90° connector for mounting to the fatshark and aim it by facing the model.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-08 -
5.8GHz FPV Antennas
RHCP 5.8 GHZ 8.25 turns Helical
This is a high gain 10-12dbi 8.25 turns helical for the 5.8 frequency. The antenna will be tuned to your exact channel’s frequency. This will require a matching pinwheel antenna for 5.8 ghz for best performance, but can be used with spironets, CL and SPW as well.
Please specify FrequencyChannel under order notes in checkout.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-06 -
5.8GHz FPV Antennas
RHCP 5.8 GHz Pentalobe V.2 1.9dbi
I developed this new Pentalobe V.2, which is an evolution not a revolution of a OMM optimized pinwheel. WIth slight more pitch angle an an extra lobe, gain and circularity are improved. Also this antenna is a better match to 50ohm compared to the older pentalobe.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-09 -
5.8GHz FPV Antennas
RHCP 5.8 GHZ PinWheel set 1.7dBi
This antenna set works quite well, and it  does provide improved video between 1-2 km on Hobbyking/Foxtec system (choose RP-SMA male connectors), or on Fatshark/ImmersionRC systems (choose SMA maleconnectors)
Range may vary, one  customer claimed a record distance of 5.5km with just fatshark attitude + 600mw irc transmitter and this pair of antennas.
These pinwheels can be used also with our 8 turn Helical for ranges up to 10KM* (400mw foxtec tx + rc305 rx)
Note: Please select the plug you want before adding the product to cart.
Â
SKU: fpv-07 -
5.8GHz FPV Antennas
RHCP 5.8 GHZ tx Pinwheel 90° SMA
A single tx pinwheel for 5.8Ghz. This antenna comes only with a 90° connector, for straight connector please select the proper item in the list. This one works very well with our 5.8 helicals….
After much testing and reports by customers I can say it outperforms most of the cp antennas out there.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-10 -
5.8GHz FPV Antennas
RHCP 5.8GHz Parasitic Disk Helix 9.3dBi-Fatshark mount- For 3-4km racing quad
This is a new development for FPV antennas. It’s a 2.75 turns helix, the turns are more closely spaced than a conventional helix, and it uses a parasitic disk to achieve higher gain (9.3dBi) and better axial ratio compared to a regular helix.
The result is a very compact moderately directional antenna with very good efficiency, and same gain as a 3 turns conventional helix. The total length is less than half that of a comparable 3 turns helix, which is slightly more than a linear patch antenna which shines if attached directly to your FPV goggles. The ease of aiming this is unbelievable it feels almost as an omni when flying your course nearby and it becomes slightly directional with very wide beam width when going far. We have taking our racing quad to 3-4km with a 200mw VTX and this antenna.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-13 -
2.4GHz FPV Antennas
RHCP Half Sphere Helix 2.4GHz
This is one of our most popular antennas, very high efficiency, 9dBi gain, 76 degrees beamwidth at -3 dB.
Easy to aim, tested good at 15+ km flights with tbs tuned lawmate tx. It performs like a 4.25 tuns, but with much smaller footprint.Â
The antenna weighs 50 grams, a full set of data is available from anechoic chamber testing for the more technical customers.
This antenna can be used for 2.4GHz analog video rx and tx, it can also be used to extend the rc radio control range.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-33 -
2.4GHz FPV Antennas
RHCP Pinwheel 2.4ghz 90° SMA (CRASHPROOF)
Custom made CP Pinwheel (SPW) antenna . These antennas are individually tuned to your frequency. They feature 1.2:1 SWR Â , gain 1.7 dbic.
These include the new CRASHPROOF soldering system, with a cnc cut copper cross with a hole in the middle, soldered around the coax sheeting. This will make it able to withstand most crashes.
These outperform all CL type antennas, as they have higher gain and better multipath rejection.
Note: Please select the plug you want before adding the product to cart.
SKU: fpv-17 -
-
Phantom 2 Vision +
STAGE 2 KIT – Pilot’s side
ClearBlueGreenRedSmokeWhite*NEW VERSION 10-21-2014″
This kit includes everything to mod both the wi-fi (fpv performance) and the rc controller (how far you can control your P2V/ P2V+) with only minimal modifications to the wi-fi extender and the radio control transmitter.
It does not require any modifications to the phantom itself
Installation instructions are here :
http://www.phantompilots.com/viewtopic.php?f=54&t=27060#p249117
Note: Please select the plug you want before adding the product to cart.
SKU: Kit-002 -
-
Phantom 2 Vision +
Stage 3 Kit -Pilot and Bird
*NEW VERSION 01-27-2015″
This kit includes EVERYTHING you need antenna wise to have great beamwidth  on the ground and great true 360 degrees coverage around the bird.
NOTE: our new pinwheels are Black in color, since our better quality coax cable is black.
It includes our popular stage 2 kit plus 2 of the 2.4ghz pinwheels and relative cables to upgrade the Video and also 2 5.8GHz pinwheels for the phantom vision and vision plus receiver and needed cables.
This latest version also includes the mounting kit V.2 as shown in the picture.
It does not include amplifiers/boosters or batteries which can be purchased separately.
SKU: kit-006 -
Phantom 2 Vision +
Stage 4 Kit
*New Version 01-27-2015″
This kit contains EVERYTHING from stage 3Â so in total you get
– stage 3
– 2.4GHz 2.5W amplifier
– 5.8GHz 2W amplifier
– 3000mah batttery with 2 leads to power both amps.
You can follow us on these Facebook groups
Phantom 3 and Long Range FPV Mods
~~These amplifier products are available for export, military, licensed amateur radio and OEM component salesÂ
SKU: kit-009 -
Phantom 2 Vision +
Bird-Side Video Upgrade Kit LHCP 2.4GHz
Thi kit contains all you need to upgrade the VIDEO only on the Phantom Vision Plus , 2 LHCP pinwheels, one 90 degrees and one straight, with the correct connectors and the correct extension cables to install on the Phantom.
This is a Plug And Play install, a matter of unplugging the stock antennas and plugging the new cables in.
SKU: kit-005 -
Phantom 2 Vision +
14 dBi LHCP 2.4GHz helix antenna
This is our longest range production antenna for 2.4GHz  with 14dBi gain.
Every aspect of this antenna is meticulously designed, built and tested, like the round copper reflector, PVC supports, enamel coated copper winding and wave trap matching strip.
Guaranteed SWR below 1.2:1 on the Phantom vision  Plus operating frequency of 2410-2440 MHz
Great distances can be achieved in conjunction with a booster.
SKU: fpv-38 -
Phantom 2 Vision +
Max Range Series LHCP 2.4GHz Pentalobe V.2
This 2 dBi pentalobe Version 2 is the highest quality omnidirectional  CP antenna you could find of any brand at any price point.
Better axial ratio and favorable pattern will translate in extra 10% range over our Pinwheel antennas.
SKU: FPV-40
